World Leader in Used Die Casting Machinery!

For Sale: One - Used - Sterling Sterlco Hot Oil Unit Heater for Process and Die Temperature Control Unit DCM 1970

Print PDF!

Status: Sold

We offer for sale, subject to prior sale and the terms listed below:

For Sale: One - Used - Sterling Sterlco Hot Oil Unit Heater for Process and Die Temperature Control Unit DCM 1970. Inventory item: DCM-1970.

Manufacturer: Sterlco

Model: M2B9016-J1 - Single Zone High Temperature Heat Transfer System

Features & Accessories:

  • Heating Capacity Zone #1: 36 KW - Total Heating Capacity: 36 KW
  • M2B Microprocessor Controls
  • Alarms for low fluid pressure, pump rotation, over temperature
  • Set points for Process, High Alarm, Low Alarm
  • Displays for Process Temperature, Return Temperature and Temperature Difference

Item Specifications for DCM-1970

Full Load Amps @ 480/3/60:
Main Heater Power (Zone #1):
36 KW
Maximum Operating Temperature:
550 degrees F
Pump Motor Size (Zone #1):
2 HP
Flow Rate (Zone #1):
24 gallons per minute
Connection size/type:
1 inch NPT
Overall Size (H x W x D):
62 x 24 x 42 inches
Approximate Shipping Weight:
725 pounds

Shipping Terms: F.O.B. Warehouse


For Sale One Used Sterling Sterlco hot oil unit heater for process and die temperature control. Model M2B9016-J1, single zone high temperature heat transfer system serial number 30C5441. Heating capacity in zone 1 is 36 KW, total heating capacity 36 KW. Equipped with One 2 HP pump motor. We sell used Sterlco oil heaters and process temperature controller units everyday. This unit is an 36 KW single zone Sterlco Equipment hot oil die temperature control unit, Die Cast Machinery LLC Inventory 1970

The following technical terms are to assist you with searches:

See jumbo large photos of this Model M2B9016-J1 36 kw Single Zone Hot Oil Temperature Control Unit

PURCHASER'S (Buyer's) RESPONSIBILITY AND INDEMNITY: Used machines, equipment or any part thereof, may not incorporate approved activating mechanisms, operator safety devices or safety guards as required by OSHA or otherwise. It shall be a Purchaser's (Buyer's) responsibility to ensure that any and all merchandise or equipment purchased from Die Cast Machinery, LLC or its affiliates is installed and operated in a proper and safe manner. Purchaser (Buyer) also acknowledges that it may have to install or change guards, safeties, warnings or other components to ensure that the merchandise or machines purchased will conform to all laws, codes, regulations, ordinances, statutes, insurance requirements and industry standards. Purchaser agrees to defend, indemnify and hold harmless Die Cast Machinery, LLC from and against all suits, claims, costs, damages and expenses, including, but not limited to, reasonable attorneys' fees, arising out of, or in connection with, the transportation, purchase, ownership, or use of the merchandise or equipment sold hereunder. Information has been obtained from sources deemed reliable, buyers should avail themselves of the opportunity to inspect the items before purchase.