World Leader in Used Die Casting Machinery!

For Sale: One - Used - Sterling Sterlco Hot Water Heating Unit DCM 3050

Print PDF!

Status: Sold

We offer for sale, subject to prior sale and the terms listed below:

For Sale: One - Used - Sterling Sterlco Hot Water Heating Unit DCM 3050. Inventory item: DCM-3050.

Manufacturer: Sterlco

Model:M2B2012-CX- Single Zone Water Heat Transfer System

Features & Accessories:

  • Heating Capacity Zone #1: 12 KW - Total Heating Capacity: 12 KW
  • M2B Microprocessor Controls
  • Water Cooling Circuit

Item Specifications for DCM-3050

Full Load Amps @ 460/3/60:
16 amp
Main Heater Power (Zone #1):
12 KW
Maximum Operating Temperature:
250 degrees F
Pump Motor Size (Zone #1):
.75 HP
Connection size/type:
1 inch NPT
Flow Rate:
30 gallons per minute
Overall Size (L x W x H):
28 x 13 x 50 inches

Shipping Terms: F.O.B. Warehouse


For Sale One Used Sterling Sterlco hot water die temperature control unit. Model M2B2012-CX, single zone hot water transfer system. Heating capacity in zone 1 is 12 KW, total heating capacity 12 KW. Equipped with One .75 HP pump motor. We sell used Sterlco hot water heaters and process temperature controller units everyday. This unit is an 12 KW single zone Sterlco Equipment hot water die temperature control unit, Die Cast Machinery LLC Inventory 3050

The following technical terms are to assist you with searches:

See jumbo large photos of this Sterlco 2012-CX

PURCHASER'S (Buyer's) RESPONSIBILITY AND INDEMNITY: Used machines, equipment or any part thereof, may not incorporate approved activating mechanisms, operator safety devices or safety guards as required by OSHA or otherwise. It shall be a Purchaser's (Buyer's) responsibility to ensure that any and all merchandise or equipment purchased from Die Cast Machinery, LLC or its affiliates is installed and operated in a proper and safe manner. Purchaser (Buyer) also acknowledges that it may have to install or change guards, safeties, warnings or other components to ensure that the merchandise or machines purchased will conform to all laws, codes, regulations, ordinances, statutes, insurance requirements and industry standards. Purchaser agrees to defend, indemnify and hold harmless Die Cast Machinery, LLC from and against all suits, claims, costs, damages and expenses, including, but not limited to, reasonable attorneys' fees, arising out of, or in connection with, the transportation, purchase, ownership, or use of the merchandise or equipment sold hereunder. Information has been obtained from sources deemed reliable, buyers should avail themselves of the opportunity to inspect the items before purchase.